Just on point A. You can configure the maximum number of conflicts allowed for each folder.

I was running into conflicts with obsidian notes. Reduced the max conflicts on those folder to zero, problem gone.

It’s in the folder specific advanced settings.

First seeing this on my home feed on Jan 7th. Relieved to find the post is 5 days old…

You mention frigate specifically. Were you running this on the system when the drive failed, or is this a future endeavour?

I bring this up because I also use frigate, and for some time I was running with a misconfigured docker compose that drove my SSD wearout to 40% in a matter of months.

Make sure that the tmpfs is configured per the frigate documentation and example config. If misconfigured like mine was, all of that IO is on disk. I believe the ramdisk is used for temp storage of camera streams, until an event occurs and the corresponding clip is committed to disk.

Good luck!

That’s great. Thank you again!

Thank you! Something concrete to go on. Is there a specific name these go by? I couldn’t find them by searching.

I think I have two issues to work through. I’m not sure I applied enough pressure to actuate the spring (access may be a limiting factor in-situ), and I was using an extremely fine gauge of wire. I doubt it would have the stiffness to push in.

Would a stalk lug work to provide added stiffness to the conductor, or does this terminal expect something malleable?

That was my initial thought, but there’s little to no give in the orange button. If anything it only felt like a little play you get between loosely coupled mechanical pieces. That’s when I tried operating it like a clamp and broke one off.

Pulling around 200W on average.

• 100W for the server. Xeon E3-1231v3 with 8 spinning disks + HBA, couple of sata SSD’s
• ~80W for the unifi PoE 48 Pro switch. Most of this is PoE power for half a dozen cameras, downstream switches and AP’s, and a couple of raspberry pi’s
• ~20W for protectli vault running Opnsense
• Total usage measured via Eaton UPS
• Subsidised during the day with solar power (Enphase)
• Tracked in home assistant

Looks like home assistant

This is what I do as well. I have a public DNS record for my internal reverse proxy IP (no need to expose my public IP and associate it with my domain). I let NPM reach out to the DNS provider to complete verification challenge using an account token, NPM can then get a valid cert from Let’s Encrypt and nothing is exposed. All inbound traffic on 80/443 remains blocked as normal.

I use the Amplipi from Micro-Nova for whole-home audio and I love it. It’s local, open source and has a Home Assistant integration.

The main unit has 6 zones, but expansions units can be added. I think it supports up to 4 simultaneous streams. We use 2x AirPlay streams, and a turn table connected via RCA, but many other options are supported. They detail it all on their website and GitHub repo.